Finance User Manual ENG -> 2. Finance Configurations -> 2.12 Finance Configurations’ Synchronization -> LUFI-21202 Synchronization Monitoring
LUFI-21202 Synchronization Monitoring
LU Introduction
The Synchronization Process Monitor shows a list of all rounds of synchronization for the instance, with data and time stamp included.
Synchronization Monitor
There are four tasks performed in this order: DATA PULL, MSG PULL, DATA PUSH, MSG PUSH.
Pulling is when the synchronizing instance receives information from the other instances. Pushing involves the synchronizing instance sending information to other instances. Data is all information entered since the last synchronization. For example, if the project created hard posted register entries, they will be sent to Coordination. Message pushing and pulling is mainly for sending and receiving of supply information.
There are three statuses:
- In progress: the task is currently running.
- OK: the tasks have been successfully executed.
- FAILED: Some problems occurred during the execution. An error message explains the failures.
If for some reason the synchronization FAILED, attempt it again. If it FAILS again please check the messages received as explained below.
How to Monitor Synchronization
Go to Synchronization/Monitoring
- Select {Synchronization Process Monitoring}
The Synchronization Monitor is open
Go to Synchronization/Monitoring
2. Expand the {Update} sub module
3. Select {Update Received Monitor}, {Update Sent Monitor}, {Message Received Monitor}, {Message Sent Monitor}
Monitor Screen
4. Select {Not Run}
The lists of entries exchanged but failed to be executed. The lines not successfully executed are shown in red with detailed error messages in the content portion of the line.
Message Received Monitor
Click on the individual line to show all relevant information to the run status and error message.
